BR #388 update

A little over halfway there with the hardware. I made two sets of punches for the washers.

Blurry, this is a close-up of the small washer punch. The bits left over fall out the side.

Blurry, this is a close-up of the small washer punch. The punched out washers fall out the side of the die.

Washer punch and die overview

Washer punch and die overview

Lots of NBWs!

Lots of NBWs!

Before I go too much further I’ll need to finish repositioning the far-side braces third bent in to a slightly higher location. At the time (it was the first bent braced) I was thinking the road would be at a lower elevation and that the brace would be partially buried. I’ve since changed my mind.

AH

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s